Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 421)

Letter Format Parameters
Chapter 17
17-23
The chamfer and radius letter format parameter is covered in ,C/,R Word
Format on page 17-23.
Function
This parameter specifies the maximum number of digits that are permitted
to the left and to the right of the decimal point when entering
Chamfering/Cornering words (,C and ,R) while in inch or metric modes.
Parameter Parameter
Number
,C/,R Word Format [515]
Range
Selection Result
(a) 3.4 inch and 4.3 metric
(b) 3.5 inch and 4.4 metric
(c) 4.3 inch and 5.2 metric
(d) 4.4 inch and 5.3 metric
(e) 5.3 inch and 6.2 metric
(f) 2.3 inch and 3.2 metric
(g) 2.4 inch and 3.3 metric
(h) 2.5 inch and 3.4 metric
(i) 2.6 inch and 3.5 metric
(j) 3.3 inch and 4.2 metric
(k) 4.2 inch and 5.1 metric
(l) 5.2 inch and 6.1 metric
Notes
This parameter is a global parameter; it applies to all axes and processes.
END OF CHAPTER
17.31
Chamfering/Corner-R Word
Letter Formats
17.32
,C/,R Word Format