3 mill type – Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set User Manual
Page 643
Miscellaneous Parameters
Chapter 37
37-3
Function
This parameter is available when your [F3] option -- Control Type has been
selected as a mill. Use this parameter to indicate to the control that you are
configuring a standard Mill or a transfer line control. This will enable
transfer line specific QuickView screens, allow downloading of AMP and
PAL without prompting for confirmation on the control, and other transfer
line specific features. The default for this parameter is a standard mill
(except in T-Line-9 standard AMP). Unless you have purchased the
T-Line-9 package we suggest leaving this parameter set as a standard mill.
Axis
Parameter
Number
All
[517]
Range
Selection
Result
(a)
Standard
(b)
Transfer Line
Notes
This is a global parameter; the value set here applies to all axes.
37.3
Mill Type