Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 579)

Chapter
31
31-1
Probing Parameters
The workstation displays this screen when the “Probing Parameters”
group is selected:
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration F1-File F2-Axis F3-Options F4-Quick Edit!
Type : Mill AXIS: X <P1> - linear P1: File : TEST
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration
When you select control type “Mill,” these parameters are displayed: When you select control type “Lathe,” these parameters are displayed:
F1-File F2-Axis F3-Options F4-Quick Edit!
Type : Lathe AXIS: X <P1> - linear P1: File : TEST
- Probing Parameters -
Probe Length Compensation : 0.00000 mm
Probe Radius Compensation : 0.00000 mm
Probe Transition : Low to High
Approach Distance (R) : 0.00000 mm
Tolerance Band Distance (D) : 0.00000 mm
Approach Rate (E) : 0.00000 mmpm
Probe Rate (F) : 0.00000 mmpm
- Probing Parameters -
Probe Length Compensation : 0.00000 mm
Probe Radius Compensation : 0.00000 mm
Probe Transition : Low to High
If the application type is: and the control type is: these parameters do not appear:
Mill/Lathe Lathe · Approach Distance (R)
· Tolerance Band Distance (D)
· Approach Rate (E)
Grinder Cylindrical
· Tolerance Band Distance (D)
· Approach Rate (E)
· Probe Rate (F)
Adaptive depth probing is discussed on page 32-1.
31.0
Chapter Overview