Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 655)

Miscellaneous Parameters
Chapter 37
37-15
Function
Use this parameter for all single-pass turning cycles for grinder control
types only.
Normally, turning cycles only repeat after execution of a block that
contains axis motion that changes the depth of a cut. Use this parameter to
cause the turning cycle to be repeated after any block is executed when the
cycle is active.
YES -- Setting a value of ‘‘YES” for this parameter causes the control to
execute the single-pass turning cycle after execution of any program block
when the cycle is active.
NO -- Setting a value of ‘‘NO” for this parameter causes the control to
execute the single-pass turning cycle only after execution of a program
block that generates axis motion in the direction of the depth of cut for
the cycle.
Axis Parameter
Number
All [82]
Range
Selection Result
(a) Yes
(b) No
Notes
This is a global parameter; the value set here applies to all axes.
37.15
Always Repeat Turning
Cycles