Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 433)

Chapter
19
19-1
Power-up G-code Parameters
This chapter covers the Power-up G-code parameters. These parameters
specify which G-code is the default G-code for a specific modal G-code
group. These default G-codes become effective when the control is
powered up or when a control reset is performed. A control reset does not
change inch/metric mode from its last programmed state. The parameter
for the inch/metric PTO state (Group 6) is only applied at power up.
They may also become effective when the control executes an
end-of-program (M02 or M30) or when an E-Stop Reset is executed.
This depends on the values of AMP parameters Reset M-- and G--codes
on M02/M30 and Control Reset on E-Stop Reset found in chapter 22.
Any other G-code group not discussed here is not configurable. The
default G-code for other G-code groups is fixed and may not be changed.
The default G-codes may be displayed on the control by selecting the
{G CODE STATUS}
screen. Refer to your programming and operation
manual for more information.
Important: The operating G-code for a specific group may be altered at
any time on the control with program commands. These override the
default G-codes until one of the operations that reactivates the default
G-codes is performed.
19.0
Chapter Overview