Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 743)

9/Series CNC AMP Reference Manual
Index
I--i
Symbols
,C/,R Word Format, 17-23
(G17, G18, G19) 1st Axis Parallel to 1, 18-5
(G17, G18, G19) 1st Axis Parallel to 2, 18-8
(G17, G18, G19) 2nd Axis Parallel to 1, 18-6
(G17, G18, G19) 2nd Axis Parallel to 2, 18-9
(G17, G18, G19) Primary Axis 1, 18-4
(G17, G18, G19) Primary Axis 2, 18-7
Numbers
1326 Motors as Spindle, 7-100
1394 Drive as Spindle, 7-100
7300 Tape Compatibility Parameters, 37-17, 25-18
7300/M06 Home Position, 37-18
9/440 CNC
catalog numbers, 7-44
number of closed loop axes, 7-44
A
A Retrace Buffer Was Deleted, 37-13
Absolute Encoder, 5-6
Absolute Encoders (analog servo), 7-47
Acc/Dec, for adaptive feed, 32-4
Acceleration and Deceleration, 10-2
Acceleration, Maximum Analog Servo, 7-84
Access Word, for patch AMP, 41-2
Adapter Baud Rate, 33-1
Adapter Block Transfer, 33-6
Adapter Last Rack Status, 33-5
Adapter Rack Number, 33-2
Adapter Rack Size, 33-3
Adapter Start Module Group, 33-4
Adaptive Depth Axis Name, 32-9
Adaptive Depth Dead Band, 32-11
Adaptive Depth Probe
(analog servo), 7-27
as feedback, 32-13
travel limit, 32-12
trip direction, 32-10
Adaptive Feed and Depth, 32-1
Adaptive Feedrate
feedrate Acc/Dec enable, 32-4
torque integral gain, 32-2
torque proportional gain, 32-3
Add to Tool Offset for Skip 1--4, 22-12
Always Repeat Turning Cycles, 25-16
AMP Editor Utility, 2-4
AMP File
Copying
From Another Project, 2-8
From Current Project, 2-7
Creating, 2-5
Opening Existing, 2-6
Selection, 2-5
AMP G-Codes
Modality (Type I, Type II), 21-7
Paramacro Calls, 21-6
Amplifier
amplifier slot number, 7-94
ID of Amplifier Rack, 7-93
Amplifier of Slot Number, 1394 Digital, 7-94
Amplifier Type, Servo, (Digital), 7-95
Analog Output Port, 7-18
Analog Servo Neg. Voltage, 7-59
Analog Servo Pos. Voltage, 7-58
Angled-Wheel Parameters
Fixed wheel angle, 35-9
Micro-feed increment, 35-10
Wheel angle source, 35-6
Wheel Axial Axis Name, 35-2
Wheel axial offset, 35-12
Wheel Axis Name, 35-3
Wheel pos. at rotation center, 35-11
Wheel rotary axis name, 35-7
Wheel Virtual Axis Name, 35-4
Wheel virtual diameter offset, 35-13
Application Selection, 2-3
Approach Distance (R), 31-5
Approach Rate (E), 31-7
Arbitrary Joggable Axis, 8-6