Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 698)

Tuning AMP at the Machine
Chapter 40
40-20
4. Set the baud rate switch to correspond to the baud rate parameter of
the selected output port.
5. Set the track select switch to “Continuous.”
At the control:
1. Place the control in E-stop.
2. Press the
{SYSTEM SUPORT}
softkey, then the
{AMP} softkey, and finally
the {UPLD/DWNLD} softkey.
This screen is displayed on the operator panel CRT:
TO
PORT A
FROM
PORT A
TO
PORT B
FROM
PORT B
UPLD / DWNLD
AMP
PAL AND I/O
SELECT OPTION USING THE UP/DOWN ARROW
3. Use the up or down arrow keys to select the AMP option.
4. Depending on which port the storage device is connected to, press the
{TO PORT A} or {TO PORT B} softkey.