Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 536)

Fixed Cycles
Chapter 25
25-16
The following sections describe the parameters that are used for turning
fixed cycles. Turning fixed cycles typically include the control
rough-turning, face-turning, and grooving cycles.
Function
All single-pass turning cycles (excluding threading and grooving) lathe
control types.
Normally, turning cycles only repeat after execution of a block that
contains axis motion that changes the depth of cut. This parameter is used
to cause the turning cycle to be repeated after any block is executed when
the cycle is active.
YES -- Setting a value of “YES” for this parameter causes the control to
execute the single-pass turning cycle after execution of any program block
when the cycle is active.
NO -- Setting a value of “NO” for this parameter causes the control to
execute the single-pass turning cycle only after execution of a program
block that generates axis motion in the direction of the depth of cut for
the cycle.
Axis Parameter
Number
All [82]
Range
Selection Result
(a) Yes
(b) No
Notes
This is a global parameter; the value set here applies to all axes and
processes. This parameter also applies to all fixed turning cycles.
25.10
Turning Cycle Parameters
25.10.1
Always Repeat Turning
Cycles