Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 520)

QuickPath Plus Parameters
Chapter 24
24-4
Function
This parameter specifies the maximum number of digits that are permitted
to the left and to the right of the decimal point for an L-word used in
QuickPath Plus programming in inch or metric modes. Use an L-word in
QuickPath Plus programming to program the length of a line.
Parameter Parameter
Number
L: Word Format [500]
Range
Selection Result Selection Result
(a) 3.4 inch and 4.3 metric (g) 2.4 inch and 3.3 metric
(b) 3.5 inch and 4.4 metric (h) 2.5 inch and 3.4 metric
(c) 4.3 inch and 5.2 metric (i) 2.6 inch and 3.5 metric
(d) 4.4 inch and 5.3 metric (j) 3.3 inch and 4.2 metric
(e) 5.3 inch and 6.2 metric (k) 4.2 inch and 5.1 metric
(f) 2.3 inch and 3.2 metric (l) 5.2 inch and 6.1 metric
Notes
This is a global parameter; the value set here applies to all axes
and processes.
END OF CHAPTER
24.4
L: Word Format