Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 701)

Tuning AMP at the Machine
Chapter 40
40-23
If the selected type of parameters are being backed up to a peripheral:
1. Press the
{TO PORT A}
or
{TO PORT B}
softkey, depending on which
port the peripheral device is connected to.
This screen is displayed on the operator panel CRT:
ACTIVE COPY PARAMETERS
FROM: AXIS CALIBRATION
TO: PORT A (or PORT B)
DEVICE: ALLEN-BRADLEY 1770-SB
BAUD RATE: 9600
PARITY: NONE
STOP BITS: 1
DATA LENGTH: 8
YES NO
If you want: Press this softkey:
the control to backup the selected type of
parameters from the peripheral device
{YES}
the backup procedure to abort {NO}