Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 563)

Solid--tapping Parameters
Chapter 29
29-3
Notes
Values must be entered for all gear ranges specified by the parameter
Number of Gears Used. If any of the gears used has no value or an illegal
value entered here, the control assumes that no gears are available and
never requests a gear change.
Use these parameters for spindle orient acceleration and acceleration
during solid--tapping. For solid--tapping, the lower of the two accelerations
(tapping axis and spindle) is applied to both motions.
Function
Enter the maximum speed in rpm at which solid--tapping can take place for
this gear of this spindle.
Parameter Parameter Number
Max tap speed for Spn 1, Gear 1 [753]
Max tap speed for Spn 1, Gear 2 [754]
Max tap speed for Spn 1, Gear 3 [755]
Max tap speed for Spn 1, Gear 4 [756]
Max tap speed for Spn 1, Gear 5 [757]
Max tap speed for Spn 1, Gear 6 [758]
Max tap speed for Spn 1, Gear 7 [759]
Max tap speed for Spn 1, Gear 8 [760]
Max tap speed for Spn 2, Gear 1 [761]
Max tap speed for Spn 2, Gear 2 [762]
Max tap speed for Spn 2, Gear 3 [763]
Max tap speed for Spn 2, Gear 4 [764]
Max tap speed for Spn 2, Gear 5 [765]
Max tap speed for Spn 2, Gear 6 [766]
Max tap speed for Spn 2, Gear 7 [767]
Max tap speed for Spn 2, Gear 8 [768]
Max tap speed for Spn 3, Gear 1 [769]
Max tap speed for Spn 3, Gear 2 [770]
Max tap speed for Spn 3, Gear 3 [771]
Max tap speed for Spn 3, Gear 4 [772]
Max tap speed for Spn 3, Gear 5 [773]
Max tap speed for Spn 3, Gear 6 [774]
Max tap speed for Spn 3, Gear 7 [775]
Max tap speed for Spn 3, Gear 8 [776]
29.2
Maximum Tapping Speed