Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 512)

Cutter Comp/Tool Tip Radius
Chapter 23
23-12
Function
Enter the percentage to which the current feedrate is to be reduced when
Automatic Corner Override has been activated.
Refer to the discussion of the AMP parameter Min Angle for Corner
Override for a discussion of the overall operation of Corner Override.
This is not a per-axis parameter. The percentage selected here is applied to
all axes and processes.
Axis Parameter
Number
All [412]
Range
0 to 100 %
An example of Corner Override
If 60% is entered here and the currently active feedrate is 100 mmpm, it is
reduced to 60 mmpm when Automatic Corner Override is activated.
The feedrate can be affected by the feedrate override switch setting. If the
feedrate override was set to 80%, the active feedrate of the above example
would be 80 mmpm. If the Corner Override % parameter was set to
60%, the control would reduce the feedrate to 60% of 80 mmpm (48
mmpm) during automatic corner override.
Notes
This is a global parameter. The value set here applies to all axes
and processes.
23.2.4
Corner Override %