Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 522)

Fixed Cycles
Chapter 25
25-2
When you select control type “Mill,” the workstation displays these
screens:
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration
- Fixed Cycle Parameters -
Page 2 of 2
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
Type : Mill Axis: X <P1> - linear P1: File : TEST
- Fixed Cycle Parameters -
Page 1 of 2
Retract amount - Peck Drilling <P1>: 25.40000 mm
Fine boring shift in Q-word : yes
Pullout angle, chamfered thrd : 5.0 degrees
Pullout dist, chamfered thrd : 5.080 Thread leads
Cycle clearance amount : 25.40000 mm
Fine Boring shift dir. G17 <P1> : G17 Primary axis 2 positive
Fine Boring shift dir. G18 <P1> : G18 Primary axis 2 positive
Fine Boring shift dir. G19 <P1> : G19 Primary axis 2 positive
Ignore dwell in tapping cycles : no
Rapid to Drilling Hole : yes
Always Repeat Turning Cycles : no
Fixed drilling axis <P1> : axis 3
Dwell time for G82, G88 & G89 : 2.00000 seconds
Dwell time for G84 & G86 : 0.20000 seconds
Forward drill time (T1) for G83 : 2.00000 seconds
Retract time (T2) for G83 : 1.00000 seconds
F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
Type : Mill Axis: X <P1> - linear P1: File : TEST
These parameters cannot be used for grinder applications. Grinder fixed
cycles parameters can be found in the Angled-Wheel parameter group and
the Miscellaneous Parameter group.