Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 700)

Tuning AMP at the Machine
Chapter 40
40-22
When the
{BACKUP AMP}
softkey is pressed, the control displays this screen
on the operator panel CRT:
BACKUP AMP
HOME CALIBRATION
REVERSAL ERROR
AXIS CALIBRATION
SELECT OPTION USING THE UP/DOWN ARROW
TO
PORT A
FROM
PORT A
TO
PORT B
FROM
PORT B
Use the up or down cursor keys to highlight the type of parameters
to backup.
Important: If the home calibration or reversal error parameters are
highlighted and the
{FROM PORT A}
or
{FROM PORT B}
softkey is pressed,
the control displays the messages “PERIPHERAL DEVICE ERROR” and
“DATA MAY BE OUTPUT TO PRINTER ONLY”.
Important: If the home calibration or reversal error parameters are
highlighted and the
{TO PORT A}
or
{TO PORT B}
softkey is pressed when
the serial communication parameters of the selected port do not correspond
to a printer, the control displays the message “DATA MAY BE OUTPUT
TO PRINTER ONLY”.
Refer to your programming and operation manual for more information on
changing the serial communication parameters of the selected port.