Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 46)

Using AMP Applications and ODS Utilities
Chapter 2
2-20
The workstation displays this screen:
Proj: TEST Appl: Download Util: Send AMP params
F2-Project F3-Application F4-Utility F5-Configuration F1-File
Download in progress
Percent transferred 50%
The workstation continuously updates and displays the percentage of
the file that has been transferred.
When the download process is complete, the workstation displays the
message:
DOWNLOAD COMPLETE
The control displays the message:
PLEASE POWER DOWN AND RESTART
9. After downloading AMP, you must turn off the control and then turn
it on again. The new AMP parameter values are then used for
software execution.
When you download an AMP file to a storage device, the workstation must
be connected to the storage device. In this procedure the specific storage
device is an Allen-Bradley 1770-SB cassette recorder.
To download an AMP file to a 1770-SB cassette recorder:
1. Connect the cassette recorder to the workstation.
2. Turn “ON” the cassette recorder.
3. Load an AMP data cassette into the cassette recorder.
4. Set the baud rate switch to “9600.”
5. Set the track select switch to “Continuous.”
2.12.2
Downloading an AMP File
to a Storage Device,
then to the Control