Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 521)

Chapter
25
25-1
Fixed Cycles
This chapter describes the available milling and turning fixed-cycle AMP
parameters.
The fixed-cycle parameters are separated into these four sections:
Parameter: Page:
Milling fixed-cycle parameters 25-3
Threading cycle parameters 25-10
Turning cycle parameters 25-16
7300 Tape Compatibility Parameters 25-18
Some of these parameters may also be changed on the control, as noted
below on with the fixed cycle parameters table.
When you select the “Fixed Cycle Parameters” group and the control type
“Lathe,” the workstation displays these screens:
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
Type : Lathe Axis: X <P1> - linear P1: File : TEST
- Fixed Cycle Parameters -
Page 2 of 2
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration
- Fixed Cycle Parameters -
Page 1 of 2
Retrct amt - Peck Drilling <P1> : 25.40000 mm
Fine boring shift in Q-word : yes
Pullout angle, chamfered thrd : 5.0 degrees
Pullout dist, chamfered thrd : 5.080 Thread leads
Cycle clearance amount : 25.40000 mm
Fine Boring shift dir. G17 <P1> : G17 Primary axis 2 positive
Fine Boring shift dir. G18 <P1> : G18 Primary axis 2 positive
Fine Boring shift dir. G19 <P1> : G19 Primary axis 2 positive
Ignore dwell in tapping cycles : no
Rapid to Drilling Hole : yes
Always Repeat Turning Cycles : no
Fixed drilling axis <P1> : axis 3
Retract amount in grooving : 0.00000 mm
Min infeed in multi threading : 0.00000 mm
Finish allow in mult threading : 0.00000 mm
F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
Type : Lathe Axis: X <P1> - linear P1: File : TEST
25.0
Chapter Overview