Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 491)

Tool Offset Parameters
Chapter 22
22-19
These subsections describe the parameters used for tool offset range
verification. These parameters check:
the maximum values entering the tool offset tables
the maximum change that can occur in either table
Parameter: Page:
Maximum Wear Offset Change 22-19
Maximum Geometry Offset Change 22-20
Maximum +/-- Wear Offset 22-22
Maximum +/-- Geometry Offset 22-23
Maximum +/-- Wear Radius 22-24
Maximum +/-- Geometry Radius 22-25
Maximum Radius Offset Change 22-26
Maximum +/-- Radius Offset 22-27
Function
Use this parameter to specify the amount that a Wear Offset may change
between successive entries.
If the operator exceeds the amount set by the system installer in AMP, the
change is not allowed. The control generates the error message “OFFSET
EXCEEDS MAX CHANGE.”
Important: The control does not perform the verification if the value, old
or new, is zero, nor does it check G10 data-setting codes.
Refer to your programming and operation manual for more information.
22.18
Tool Offset Range
Verification Parameters
22.19
Maximum Wear Offset
Change