Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 268)

Jog Parameters
Chapter 8
8-10
Function
The value specified for this parameter is equal to the speed at which a
continuous jog move takes place when <SPEED/MULTIPLY> on the MTB
panel is set to MED X100.
Important: Incremental jogs jog at the value assigned to the Third Jog
Speed parameter. This value may be overridden by the PAL program.
Axis Parameter
Number
Axis Parameter
Number
(1) [1372] (7) [7372]
(2) [2372] (8) [8372]
(3) [3372] (9) [9372]
(4) [4372] (10) [10372]
(5) [5372] (11) [11372]
(6) [6372] (12) [12372]
Range
Second Jog Speed to Fourth Jog Speed value
The minimum and maximum values that may be set for this parameter are
dependant on the value set for the parameters “Second Jog Speed” and
“Fourth Jog Speed.”
Set each parameter independently for each axis.
Notes
This is a global parameter. The value set here applies to all axes.
The default setting for <SPEED/MULTIPLY> on the pushbutton MTB
panel is LOW X1.
8.3.3
Third Jog Speed