Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 641)

Chapter
37
37-1
Miscellaneous Parameters
This chapter describes miscellaneous parameters that should be set. These
miscellaneous parameters do not in any way refer to the miscellaneous
functions that are called using an M- or B-code.
The workstation displays these screens when the “Miscellaneous
Parameters” group is selected:
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
Type : Lathe Axis: X <P1> - linear P1: File : TEST
- Miscellaneous Parameters -
Page 2 of 2 Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
- Miscellaneous Parameters -
Page 1 of 2
2nd Character of The Password : 66
3rd Character of The Password : 45
4th Character of The Password : 68
5th Character of The Password : 52
6th Character of The Password : 32
Move Tool to 7300/M06 Position (1) : False
7300/M06 Home Position (1)
: False
Battery BackUp Installed : Yes
Type of Operator Panel : Monochrome
System Scan Time : 12 ms
Reset G92 offsets <P1> : yes
Lathe type : Lathe C
Control Reset on E-stop Reset : True
Dwell type : Time & spn revs
Threading E word definition : Num of Threads / Inch
Secondary Aux Function Word : None
Block delete type : Delete rest
Reset M&G codes on M02/M30 : yes
Reset Coord Offset on M02/M30 : yes
Cancel Tool Offset on M02/M30 : yes
High Speed Input Trigger Point : Rising edge
Block Retrace Limit <P1> : 8
Scaling Allowed (1) : True
1st Character of The Password : 65
Type : Lathe Axis: X <P1> - linear P1: File : TEST
The above screens may differ slightly depending on the control you use.
Important: When the selected control type is “Mill,” the Lathe type
parameter is replaced with the Mill type parameter.
37.0
Chapter Overview