Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 90)

Chapter 4
Axis Parameters
4-6
Function
These parameters are only available for dual process applications. Use
these parameters to specify the process that controls the axis. Each axis on
the control must be assigned a specific process. You can choose either
process 1 or process 2.
Important: You cannot use this parameter if the axis is a spindle. Refer to
the next section for information on process spindles.
Parameter Parameter
Number
Axis One’s Process [665]
Axis Two’s Process [666]
Axis Three’s Process [667]
Axis Four’s Process [668]
Axis Five’s Process [669]
Axis Six’s Process [670]
Axis Seven’s Process [671]
Axis Eight’s Process [672]
Axis Nine’s Process [673]
Axis Ten’s Process [674]
Axis Eleven’s Process [675]
Axis Twelve’s Process [676]
Range
Selection Result
(a) Process 1
(b) Process 2
Notes
Each of these parameters must be set independently for its corresponding axis.
4.2
Axis Process