Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 82)

Configuring Axes
Chapter 3
3-18
4. Enter the characters for the first half of the name and press
[Enter]
.
Important: When you rename a process, you can leave the first half of
the name unchanged by pressing [Esc] .
5. The menu for the second half of the name appears. Enter the
characters for the second half of the name and press [Enter] .
Important: When you rename a process, you can leave the second half of
the name unchanged by pressing
[Esc]
.
Use the Configure Process to assign active or inactive status to a process.
To configure a process:
1. Press [F5] to pull down the F5-Process menu.
2. Press [G] to select the Configure Process option.
The following screen will appear:
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
Type : Lathe AXIS: X <P1> - linear File : TEST
-- Axis Parameters --
Axis One’s Name : X
Axis Two’s Name : Y
Axis Three’s Name : Z
Axis Four’s Name : U
Axis Five’s Name : V
Axis Six’s Name : W
Axis Seven’s Name : C
Axis Eight’s Name : A
Axis Nine’s Name : B
Axis Ten’s Name : S
Axis Eleven’s Name : S
Axis Twelve’s Name : S
Axis Thirteen’s Name : S
Page 1 of 4
P1:
Select Process to Configure:
Process [1]:
Process [2]:
- Active - High (1)
- Inactive - High (2)
3. Press either
[1]
or
[2
] to specify the process you want to configure.
3.9.5
Configure Process