Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 347)

Chapter
13
13-1
Spindle 2 Parameters
Use these parameters to define spindle operation for Spindle 2. Each
spindle is considered a separate axis. These parameters must be set
separately for each spindle.
These parameters include:
DAC Voltage and Spindle Gear Parameters
Spindle DAC Output Ramping
Voltage at Max for Gears 1-8
Spindle Deviation Tolerance
Number of Gears Used
Minimum Spindle Speed - Gear 1-8
Maximum Spindle Speed - Gear 1-8
Deviation Detection Filter Time
Spindle Orienting Parameters
Spindle Marker Calibration
Orient Speed
Default Orient Direction
Default Orient Angle
Orient Imposition Band
Important: Only Spindle 1 may be used in conjunction with Virtual C or
Cylindrical Interpolation.
Important: Many of the parameters in this section are not used when using
a 1394 drive/1326 motor combination as a spindle. Refer to page 7-100 for
details on this special spindle configuration.
This feature is not available on the 9/230 control.
13.0
Chapter Overview