Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 329)

Chapter
12
12-1
Spindle 1 Parameters
Use these parameters to define spindle operation for spindle 1.
These parameters must be set separately for each spindle.
These parameters include:
Spindle DAC Output Ramping
Voltage at Max for Gear 1-8
Spindle Deviation Tolerance
Number of Gears Used
Minimum Spindle Speed - Gear 1-8
Maximum Spindle Speed - Gear 1-8
Dev. Detection Filter Time
Spindle Marker Calibration
Orient Speed
Default Orient Direction
Default Orient Angle
Orient Inposition Band
Important: Note that if the spindle is to also be used with virtual C or
Cylindrical Interpolation you must set the parameters in chapter 26.
Only the controlling spindle may be used with Virtual C or Cylindrical
Interpolation. The default controlling spindle is the spindle that is assigned
first or the spindle selected with a G12 code. For instance, if you are using a
Dual --Processing control and assign spindle 1 to process 1, and spindle 2 to process
2, both spindle 1 and spindle 2 may be used with V irtual C or Cylindrical
Interpolation.
Important: Many of the parameters in this section are not used when using
a 1394 drive/1326 motor combination as a spindle. Refer to page 7-100 for
details on this special spindle configuration.
12.0
Chapter Overview