Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 753)

9/Series CNC AMP Reference Manual
Index
I--xi
T
T: Tool Number Integer Format, 17-22
T--Code Format, 22-3
T--word Programming Method, 22-18
Tapping Cycle, Ignore Dwell, 25-7
Target Offset For Skip 01 -- 04, 22-13
Teeth on gear for pos FB, 7-54
Teeth on Lead Screw for pos FB, (Analog), 7-56
Teeth on Lead Screw for vel FB, (Analog), 7-69
Teeth on Motor Gear for vel FB, (Analog), 7-68
Terms and Conventions, 1--3
Third Jog Increment, 8-16
Third Jog Speed, 8-10
Threading, pullout distance, 25-10
Threading Cycle Parameters, 25-10
Threading E Word Definition, 37-7
Threshold for Friction Compensation, 7-108
Time, Minimum Block Cycle, 37-20
Tolerance Band Distance (D), 31-6
Tool Gauging Cycle Parameters, G37, 22-10
Tool Geometry Mode, 22-6
Tool Length Axis, 22-4
Tool Life Monitor Parameters, 22-17
Tool Magazine/Turret Parameters, 22-14
Tool Number/Group Boundary, 22-17
Tool Offset Cancel, 22-9
Tool Offset Range Verification Parameters, 22-19
Tool Offset Setup Parameters, 22-3
Tool Table Motion, 22-16
Tool Tip Radius Compensation (TTRC), Generated Blocks,
23-5
Tool Wear Mode, 22-8
Torque
Hardstop Detection Torque, 7-82
hardstop holding, 7-83
torque filter cutoff frequency, 7-86
Torque (+), Maximum % Rated, (Analog), 7-79
Torque (--), Maximum % Rated, (Analog), 7-78
Torque control, using Acc/Dec with, 32-4
Torque Control (G25), Adaptive Feed, 32-1
Torque Filter Cutoff Frequency, analog servo, 7-86
Torque Offset Direction, (Analog), 7-81
Torque Offset Percentage, (Analog), 7-80
Trailing Zero Suppression Mode, 16-4
Transfer Line Selection, mill type, 37-3
Travel Limit, adaptive depth probe, 32-12
Traverse Jog Speed, 8-23
Trigger Method for Interrupt 0 -- 3, 26-3
Turning Cycle Parameters, 25-16
Type of Macro Call, to #9010 to #9019 (Type I), 21-9
U
Units, Selecting, 3-12
Uploading AMP Files, 40-19
Uploading AMP files, 2-24
Uploading and Downloading AMP, 40-17
Use AMP Skip Feedrate, 9-11
Use Probe Feedback for Servos, 32-13
V
Values, for patch AMP, 41-4
Ve Integrator Discharge Rate, (Analog), 7-75
Velocity Error Integrator Discharge Rate, (Analog), 7-75
Velocity Feedback Counts/Cycle, 7-65
Velocity Feedback Type, (Digital), 7-62
Velocity Integral Gain, (Digital), 7-72
Velocity Loop (Analog), Closed by Amplifier, 7-16
Velocity Loop Feedback Port, (Digital), 7-61
Velocity Loop Parameters, 7-60
Velocity Proportional Gain
(Digital), 7-70
online, 40-13
Velocity Step For ACC/DEC, 10-7
Vertical compensation axis, 27-4