Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 675)

Chapter
39
39-1
Reserved Custom Parameters
Parameters found in this group of AMP parameters are for use with
Allen-Bradley custom software that may have been ordered for your
specific machine. It is not necessary to alter any of these parameters unless
one of the custom software packages has been purchased.
If you have purchased a custom software package, a detailed description of
these parameters should have been provided in a separate document that
accompanies this software. Refer to this document for details on any
parameters in this group. If this document is not available, contact the
system installer that you purchased the specific machine from or your
Allen-Bradley sales representative.
Important: If any of the motors used for this application are
1326AS--xxxxx--xx (low inertia rare--earth type) you need to configure the
Reserved Custom Parameter # 14 and the Reserved Custom Parameter
# 15. Refer to pages 7-49, 7-67, 39-2, and 39-3 for more details.
39.0
Reserved Custom
Parameters