Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 695)

Tuning AMP at the Machine
Chapter 40
40-17
To backup information from the control’s flash memory to the control’s
RAM memory, press the
{FROM BACKUP}
softkey. The selected
information, AMP or axis calibration data, is copied from the control’s
flash memory to the control’s RAM memory.
The control displays the message “PLEASE POWER DOWN AND
RESTART”. The control must be turned off and then on again after the
information is backed up from flash memory to RAM.
One of the softkeys displayed after accessing the online AMP softkeys is
the
{UPLD/DWNLD} softkey.
This softkey is used to upload or download PAL and I/O files or AMP
files. Refer to your PAL reference manual for more information on
uploading or downloading PAL and I/O files.
Uploading and downloading AMP files is covered in these sections:
Downloading AMP Files
Uploading AMP Files
Important: Refer to chapter 2 for information on downloading AMP from
the workstation to the control or uploading AMP from the control to
the workstation.
To download an AMP file from a storage device to the control:
At the storage device:
1. Connect the storage device to the control.
Refer to your integration and maintenance manual for more information
on cabling.
2. Set the baud rate switch to “1200.”
3. Set the track select switch to “Continuous.”
40.8
Uploading and Downloading
AMP
40.9
Downloading AMP Files