Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 43)

Using AMP Applications and ODS Utilities
Chapter 2
2-17
On the control, you must configure port B for serial communication. The
serial communication parameters of this port must correspond to those of
the workstation. To display the serial communication parameters of
port B:
1. Press the {SYSTEM SUPORT} softkey on the operator panel.
2. Press the {DEVICE SETUP} softkey.
3. Use the right arrow key on the operator panel keyboard to change the
display to port B.
If the serial communication parameters of these ports do not correspond to
those of the workstation, refer to your programming and operation manual
for procedures on changing serial communication parameters.
After you connect the workstation to the control:
1. Return to the main menu line of ODS.
2. Press
[F3]
to pull down the Application menu.
The workstation displays this screen:
Proj: TEST Appl: none Util: none
F2-Project F1-File
AMP (A)
PAL (P)
I/O Assignments (I)
Part Program (R)
Upload (U)
Download (D)
F4-Utility F5-Configuration F3-Application
3. Select the Download application.