Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 277)

Jog Parameters
Chapter 8
8-19
By pressing the CYCLE START button, the jog retract feature lets you:
1. stop part program execution
2. jog the tool to another location
3. return the tool to its original position (see Figure 8.1)
The control remembers up to the number of jog moves specified by the
parameter Max Jogs in Retracts and returns the tool to the part by the
same path and at the feedrate specified by the parameter Jog Retract
Velocity.
Refer to chapter 8 of your lathe or mill programming and operation manual
for details on using the jog retract feature.
Parameter: Page:
Jog Retract Velocity 8-21
Maximum Jogs in Retracts 8-22
Important: Jog retract moves are performed as normal jogs and are
subject to the feedrates and resolutions that that jog type has been assigned.
8.5
Jog Retract