Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 573)

Cylindrical/Virtual C Parameters
Chapter 30
30-9
Function
This parameter specifies the name of the machine axis that will be end face
milling axis during virtual C end face milling. This axis will be
perpendicular to the diameter and feed axes during virtual C end
face milling.
Important: The machine axis named as the end face milling axis must not
be an axis in the current machine configuration.
Parameter Parameter Number
Single Process Process 1 Process 2
End Face Milling Axis [238] [20238] [21238]
Range
Selection Result Selection Result
(a) A (f) W
(b) B (g) X
(c) C (h) Y
(d) U (i) Z
(e) V (j) none
Notes
This parameter is used for lathe controls only.
In the dual--processing lathe, this is a per process parameter. The value set
in the parameters applies to all of the axes assigned to that process.
This feature is not available on the 9/230 control.
30.10
End Face Milling Axis