Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 474)

Tool Offset Parameters
Chapter 22
22-2
When you select “Tool Offset Parameters” from the main menu screen,
these screens become available:
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
Type : Mill AXIS: X <P1> - linear P1: File : TEST
- Tool Offset Parameters -
Page 3 of 3
Maximum +/- Geometry Radius <P1> : 390.000000 in
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
Type : Mill AXIS: X <P1> - linear P1: File : TEST
- Tool Offset Parameters -
Page 2 of 3
Proj: AMPTEST Appl: AMP Util: Edit
F2-Project F3-Application F4-Utility F5-Configuration
- Tool Offset Parameters -
Page 1 of 3
Target offset for skip 01 <P1> : Wear Offset
Target offset for skip 02 <P1> : Wear Offset
Target offset for skip 03 <P1> : Wear Offset
Target offset for skip 04 <P1> : Wear Offset
Number of Tool Pockets <P1> : 78
Tool Table Motion <P1> : Bi-directional
Tool Number/Group Boundary <P1> : 100
T-word Programming Method <P1> : Return Tool in M06
Maximum Wear Offset Change <P1> : 390.000000 in
Maximum Geometry Offset Change <P1>: 390.000000 in
Maximum +/- Wear Offset <P1> : 390.000000 in
Maximum +/- Geometry Offset <P1> : 390.000000 in
Maximum +/- Wear Radius <P1> : 390.000000 in
Tool Length Axis <P1> : Axis 3
Maximum Tool Offset Number <P1> : 40
Tool Geometry mode <P1> : immed shift, delay move
Tool Wear mode <P1> : immed shift, delay move
Tool offset cancel<P1> : Cancel Geom & Wear
Position tolerance for Skip 1<P1> : 1.00000 mm
Position tolerance for Skip 2 <P1> : 1.00000 mm
Position tolerance for Skip 3 <P1> : 1.00000 mm
Position tolerance for Skip 4 <P1> : 1.00000 mm
Add to Tool Offset for Skip 1 <P1> : True
Add to Tool Offset for Skip 2 <P1> : True
Add to Tool Offset for Skip 3 <P1> : True
Add to Tool Offset for Skip 4 <P1> : True
F1-File F2-Axis F3-Options F4-Quick Edit! F5-Process
Type : Mill AXIS: X <P1> - linear P1: File : TEST
Important: If the selected control type is “Lathe,” the parameter Tool
Length Axis is replaced by the parameter T-code Format, and the
parameter T-word ‘‘Programming Method” is not available.
If the selected control type is “Grinder,” the parameters Maximum +/--
Radius Offset and Maximum Radius Offset Change become available.