Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 57)

Using AMP Applications and ODS Utilities
Chapter 2
2-31
The operator panel CRT displays this screen:
Figure 2.5
Upload Parameter Screen
COPY PARAMETERS
FROM: AMP
TO: PORT A (or PORT B)
DEVICE: ALLEN-BRADLEY 1770-SB
BAUD RATE: 1200
PARITY: NONE
STOP BITS: 1
DATA LENGTH: 8
YES NO
6. Refer to the table below.
If you want to: Press this softkey:
upload the stored AMP file from the control to
the storage device
{YES}
abort the upload procedure {NO}
To upload an AMP file to the workstation from a storage device:
At the storage device:
1. Connect a storage device to the workstation’s input/output port.
2. Load the AMP data cassette, which contains the selected AMP file, in
the storage device.
3. Set the baud rate to “9600.”
4. Set the track select switch to “Continuous.”