Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 286)

Feedrate Parameters
Chapter 9
9-4
Refer to chapter 13 of your lathe or mill programming and operation
manual for additional information.
Axis Parameter
Number
Axis Parameter
Number
(1) [1201] (7) [7201]
(2) [2201] (8) [8201]
(3) [3201] (9) [9201]
(4) [4201] (10) [10201]
(5) [5201] (11) [11201]
(6) [6201] (12) [12201]
Range
0.00000 ipm or mmpm to Rapid Feedrate for Positioning
Notes
This parameter must be set independently for each axis.
On angled-wheel grinding systems the maximum cutting feedrate for the
virtual axis is a function of the angle of the wheel axis, the angle of the
move, and the maximum cutting feedrates for the wheel axis and the axial
axis. The physical speed of any given axis can exceed the cutting feedrate
however, the wheel feed relative to the part will not exceed the cutting
feed.
Feedrate Override parameters include:
Parameter: Page:
Rapid Override in Dry Run 9-5
“F1” Rapid Override Percent 9-6
External decel speed (cutting) 9-7
External decel speed (posit.) 9-8
9.2
Feedrate Override
Parameters