Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 281)

Jog Parameters
Chapter 8
8-23
Function
The value specified for this parameter is equal to the speed at which a
continuous jog move takes place when the traverse jog speed is selected
(typically this is selected by holding down the <TRVRS> button when
jogging). This traverse feedrate may be modified by the operator using the
<RAPID FEEDRATE OVERRIDE> switch.
Axis Parameter
Number
Axis Parameter
Number
(1) [1003] (7) [7003]
(2) [2003] (8) [8003]
(3) [3003] (9) [9003]
(4) [4003] (10) [10003]
(5) [5003] (11) [11003]
(6) [6003] (12) [12003]
Range
0.00600 mmpm to 10160.00004 mmpm
or
0.00024 ipm to 400.00000 ipm.
Notes
This parameter must be set independently for each axis.
END OF CHAPTER
8.6
Traverse Jog Speed