Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 365)

Chapter
14
14-1
Spindle 3 Parameters
Use these parameters to define spindle operation for Spindle 3.
These parameters must be set separately for each spindle.
These parameters include:
Spindle DAC Output Ramping
Voltage at Max for Gear 1-8
Spindle Deviation Tolerance
Number of Gears Used
Minimum Spindle Speed - Gear 1-8
Maximum Spindle Speed - Gear 1-8
Dev. Detection Filter Time
Spindle Marker Calibration
Orient Speed
Default Orient Direction
Default Orient Angle
Orient Imposition Band
Important: Only Spindle 1 may be used in conjunction with Virtual C
or Cylindrical Interpolation.
Important: Many of the parameters in this section are not used when using
a 1394 drive/1326 motor combination as a spindle. Refer to page 7-100 for
details on this special spindle configuration.
Three spindles are not supported by 9/230, 9/260 or 9/440 controls.
14.0
Chapter Overview