Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 287)

Feedrate Parameters
Chapter 9
9-5
Function
This parameter determines whether the Rapid Feedrate Override switch
affects the Feedrate when Dry Run is active. Note that Dry Run replaces
all feedrates programmed with an F-word in a program with the Maximum
cutting feedrate. Rapid moves remain at the rapid feedrate. Refer to
chapter 8 of your programming and operation manuals for additional
information on Dry Run mode.
True -- for this parameter means that <RAPID FEEDRATE OVERRIDE>
affects the feedrate for rapid moves when a program is executing in Dry
Run. The programmed feedrates are overridden using <FEEDRATE
OVERRIDE>.
False -- for this parameter means that the Rapid Feedrate Override switch
is ignored when a program is executing in Dry Run mode. Both rapid and
programmed feedrates are overridden using <FEEDRATE OVERRIDE>
on the MTB panel.
Axis Parameter
Number
All [66]
Range
Selection Result
(a) True
(b) False
Notes
This is a global parameter. The value entered here applies to all axes.
9.2.1
Rapid Override in Dry Run