Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 267)

Jog Parameters
Chapter 8
8-9
Function
The value specified for this parameter is equal to the speed at which a
continuous jog move takes place when <SPEED/MULTIPLY> on the MTB
panel is set to the second position.
Axis Parameter
Number
Axis Parameter
Number
(1) [1371] (7) [7371]
(2) [2371] (8) [8371]
(3) [3371] (9) [9371]
(4) [4371] (10) [10371]
(5) [5371] (11) [11371]
(6) [6371] (12) [12371]
Range
Lowest Jog Speed to Third Jog Speed value
The minimum and maximum values that may be set for this parameter are
dependant on the value set for the parameters “Lowest Jog Speed” and
“Third Jog Speed.”
Set each parameter independently for each axis.
Notes
The default setting for <SPEED/MULTIPLY> on the pushbutton MTB
panel is LOW X1.
8.3.2
Second Jog Speed