Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 530)

Fixed Cycles
Chapter 25
25-10
Range
Selection Result Selection Result
(a) none (h) Axis 7
(b) Axis 1 (i) Axis 8
(c) Axis 2 (j) Axis 9
(d) Axis 3 (k) Axis 10
(e) Axis 4 (l) Axis 11
(f) Axis 5 (m) Axis 12
(g) Axis 6
Notes
This is a global parameter; the value set here applies to all axes.
The following sections describe the parameters that are used for the
threading cycles. These threading-cycle parameters are applicable only on
lathes. The threading cycle parameters in this section are used for the
single pass threading cycle, and the multi-pass threading cycle. No AMP
parameters are available here for the G33 and G34 single pass
threading modes.
Function
Use this parameter for lathe controls when cutting either the single pass or
multiple pass threading cycles. The G-codes for these cycles are:
G Code System Single Pass Multiple Pass
A G92 G76
B G78 G76
C G21 G78
This parameter determines the pullout distance “r” for the threading
chamfer feature.
25.9
Threading Cycle Parameters
25.9.1
Pullout Distance, Chamfered
Thread