Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 266)

Jog Parameters
Chapter 8
8-8
Function
The value specified for this parameter is equal to the speed at which a
continuous jog move takes place when <SPEED/MULTIPLY> on the
MTB panel is set LOW X1.
Axis Parameter
Number
Axis Parameter
Number
(1) [1370] (7) [7370]
(2) [2370] (8) [8370]
(3) [3370] (9) [9370]
(4) [4370] (10) [10370]
(5) [5370] (11) [11370]
(6) [6370] (12) [12370]
Range
0.00600 mmpm to Second Jog Speed value
or
0.00024 ipm to Second Jog Speed value
The maximum value that may be set for this parameter is dependant on the
value set for the parameter “Second Jog Speed.”
Set each parameter independently for each axis.
Notes
The default setting for <SPEED/MULTIPLY> on the pushbutton MTB
panel is LOW X1.
8.3.1
Lowest Jog Speed