Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 575)

Cylindrical/Virtual C Parameters
Chapter 30
30-11
Function
This parameter specifies the integrand name of the end face milling axis
during virtual C end face milling. The end face axis integrand name is
used while programming in modes where an integrand letter is expected.
The numeric value programmed with the end face axis integrand name is
the integrand value for the end face milling axis. This value is used by the
control to reference a point on the end face milling axis that is used in
calculating arc centers, fixed cycle variables, and other similar functions.
Parameter Parameter Number
Single Process Process 1 Process 2
End Face Axis Integrand Name [240] [20240] [21240]
Range
Selection Result
(a) I
(b) J
(c) K
(d) None
Notes
This parameter is used for lathe controls only.
In the dual--processing lathe, this is a per process parameter. The value set
in the parameters applies to all of the axes assigned to that process.
This feature is not available on the 9/230 control.
30.12
End Face Axis Integrand
Name