Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 665)

Miscellaneous Parameters
Chapter 37
37-25
Function
Use this parameter to determine if G92 and Set Zero offsets will clear
when you perform a control reset. If you choose Yes, G92 and Set Zero
Offsets will clear by a control reset, a program command, or by power up.
If you choose No, G92 and Set Zero Offsets will clear only by a program
command or by power up.
Axis Parameter Number
Single Process Process 1 Process 2
All [91] [20091] [21091]
Range
Selection Result
(a) Yes
(b) No
Notes
This is a global parameter; the value set here applies to all axes. On dual
processing controls you must set a value for each processes independently.
END OF CHAPTER
37.24
Reset G92 Offsets