Rockwell Automation 8520-ARM2 9/Series CNC AMP Reference Manual Documentation Set - Manual (Page 616)

Angled Wheel Parameters
Chapter 35
35-4
Function
Use this parameter to select the virtual axis. This axis is perpendicular to
the axial axis.
Virtual Axis
(typically X)
Part
Wheel Axis
(typically W)
Wheel Axis
Angle +q
Axial Axis
(typically Z)
Axis
Parameter
Number
All [611]
The axis name selected here can not be:
an axis name used by any other real axis
the QuickPath Plus angle word (see chapter 20)
Check which axis names have already been used using the F2 option.
Range
Selection Result Selection Result
(a) A (f) W
(b) B (g) X
(c) C (h) Y
(d) U (i) Z
(e) V (i) none
Non-angled-wheel grinders should have this parameter set as “none” (i).
35.3
Wheel Virtual Axis Name