HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 138)

138
4.4 Pr
ogr
am Section Code
„ Simple tool description:
„ The tools are suitable only for simple traverse paths and turning
cycles (G0...G3, G12, G13; G81...G88).
„ Contour follow-up is not taken into account.
„ The tool radius compensation is conducted.
„ Simple tools are not transferred into the database.
Example of turret table
Editing the turret assignment
For every occupied turret pocket in the TURRET section:
„ The tool ID number is entered if the tool is in the database.
„ The tool description is entered directly if it applies to temporary
tools.
„ If you do not program the TURRET, the tools entered
in the tool list will be used.
„ The names _SIM... and _AUTO... are reserved for
temporary tools (simple tools and tools without ID
number). Tool entries are valid as long as the NC
program is activated in the simulation or in Automatic
mode.
REVOLVER 1 [TURRET]
T1 ID"342-300.1" Tool from the database
T2 WT1 X50 Z50 R0.2 B6 Simple tool description:
T3 WT122 X15 Z150 H0 V4 R0.4 A93 C55 I9 K70 Extended tool description without entry in the
database
T4 ID"ERW.1" WT112 X20 Z150 H2 V4 R0.8 A95 C80 B9 K70 Extended tool description with entry in the database
. . .
Parameters of the Tool dialog box:
T number Position on tool carrier
ID Identification number (reference to database).
“Extended input”
button Switching to extended tool description
“Simple tool”
button Switching to simple tool description