HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 481)

HEIDENHAIN CNC PILOT 4290 481
6.12 Assigning At
tr
ibut
es
Assigning the “Exclusion from machining” attribute to the
elements of the turning contour:
U Select “Attribute > Feed/Peak-to-valley > Exclusion from
machining” in the finished part menu.
U Select the entire contour, a contour section or individual contour
elements (see “Selections” on page 448).
U TURN PLUS assigns the attribute.
Assigning the “Exclusion from machining” attribute to a C/Y-axis
contour:
U Activate the front-face, rear-face or lateral-surface window.
U Select “Attribute > Machining attribute > Drill (or Mill) > Exclusion
from machining” in the finished part menu.
U Select the drilling or milling contour.
U TURN PLUS assigns the attribute.
Deleting machining attributes
You can delete the machining attributes of holes and milling contours.
Deleting the “Drill” machining attribute:
U Select “Attribute > Machining attribute > Drill > Delete drilling
attributes” in the finished part menu.
U Select the bore hole.
U TURN PLUS deletes the machining attributes of this hole.
Deleting the “Mill” machining attribute:
U Select “Attribute > Machining attribute > Mill > Delete milling
attributes” in the finished part menu.
U Select the milling contour.
U TURN PLUS deletes the machining attributes of this milling contour.