HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 373)

HEIDENHAIN CNC PILOT 4290 373
5.1 Simulation Mode of Oper
ation
Simulation mode
You can set by soft key whether the simulation will be run
continuously or blockwise.
U Single block: Stop after every NC source block
U Basic block
„ Contour simulation: Stop after every contour
element
„ Machining or motion simulation: Stop after every
traverse path
U Without stop (single block and basic block soft keys
are not pressed): The simulation is conducted without
stop.
U Menu item “Stop”: The simulation stops.
U Menu item “Continue”: The simulation resumes.
During a simulation stop you can switch the block mode, edit the
settings or call the dimensioning function.