HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 605)

HEIDENHAIN CNC PILOT 4290 605
7.
6 Mac
h
ining P
a
ra
met
e
rs
21 – Name of the subroutines
TURN PLUS uses expert programs for functions such as workpiece
transfer for full-surface machining. In this parameter you can define
which expert programs (subprograms) are to be used. Enter the
subprogram names.
22 – Sequence of tool selection
If more than one slide is used for machining, define the sequence in
which TURN PLUS is to load the tool carriers. Enter the slide numbers
one after the other, without separators (example: “351“ means $3,
then $5, then $1).
Expert programs
SP 100098: Parting
SP 100099: Bar loader
SP EXUMS12 (currently no meaning)
SP EXUMS12A (currently no meaning)
SP MEAS01: Measuring cut
SP UMKOMPL: Rechucking for lathes with opposing spindle
SP UMKOMPLA: Parting and rechucking for lathes with opposing
spindle
SP UMHAND: Rechucking for lathes without opposing spindle
SP ABHAND: Parting and rechucking for lathes without opposing
spindle
Sequence of tool selection
1st setup [123456]
Sequence in which TURN PLUS loads the tool carriers for the
first setup.
2nd setup [123456]
Sequence in which TURN PLUS loads the tool carriers for the
second setup.