HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 412)

412
6.6 F
o
rm
Elements
Recess type D (sealing ring)
This form element defines an axial or radial recess on the outside or
inside of the contour. The recess is assigned to the previously
selected reference element.
Parameters
X Starting point for radial recess
Z Starting point for axial recess
I Diameter of recess base (only for axial recess)
Ii „ Axial recess: Recess depth
„ Radial recess: Recess width (pay attention to sign!)
Ki „ Axial recess: Recess width (pay attention to sign!)
„ Radial recess: Recess depth
Corners:
„ No: No chamfer/rounding
„ Chamfer: Chamfered edge
„ Rounding: Rounded corner
B Width of chamfer or radius of rounding at both sides of the
recess
R Radius at bottom, inside radius in both recess corners