HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 144)

144
4.4 Pr
ogr
am Section Code
AUXILIARY CONTOUR section
In the AUXILIARY CONTOUR section you describe the auxiliary
contours of the turning contour.
FRONT section
In the FRONT section you describe the contours of the front face.
REAR SIDE section
In the REAR SIDE section you describe the contours of the back face.
SURFACE section
In the SURFACE section you describe the cylindrical-surface contours.
MACHINING section
In the MACHINING section you program the machining operations.
This code must be included.
END code
The END section concludes the NC program. This code must be
programmed. It replaces M30.
ZUORDNUNG [ASSIGNMENT] instruction $..
The ASSIGNMENT instruction assigns the subsequent machining
operations to the given slides. If more than one slide is listed the NC
blocks are executed on the given slides.
If in addition a slide code is shown, the slides shown under $.. are
used.
Parameters
Z Position of front face contour
Parameters
Z Position of the rear-face contour
Parameters
X Reference diameter of lateral-surface contours.
Parameters
Slide Slide number(s)