M commands in manual control mode, 2 manual contr o l mode – HEIDENHAIN CNC Pilot 4290 V7.1 User Manual
Page 63
HEIDENHAIN CNC PILOT 4290
63
3.2 Manual Contr
o
l Mode
Insert the nominal tool
U
Select T. Enter the turret position, or
U
the next turret position, or
U
the previous turret position, or
Functions of the tool change:
Move the tool into position
Calculate “new” tool dimensions
Display “new” actual values in the position display
M commands in Manual Control mode
In the menu group M you either type in the M function to be run or you
select the desired function from the menu.
To run an M function:
U
Select M > M direct
U
Enter the M number (“M function” dialog box)
U
Cycle Start runs the M function
U
“Cycle stop” exits the dialog box
To select and run an M function:
U
Select “M function”
U
Using the menu, select the M function
U
Cycle Start runs the M function
U
“Cycle stop” exits the dialog box
The content of the M menu depends on the machine.
Yours may differ from the example shown here.