Program selection, 5 a u to matic mode – HEIDENHAIN CNC Pilot 4290 V7.1 User Manual
Page 82
82
3.5 A
u
to
matic Mode
Program selection
The CNC PILOT interprets the NC program before it can be activated
with Cycle Start. “#-Variables” are entered during the translation
process. A “restart” prevents a new translation, while a “new start”
forces a new translation.
Program selection
Select Prog > Program selection The CNC PILOT opens the list of NC
programs.
Select the NC program
The NC program is loaded without previous translation if:
No changes were made to the program or tool list.
The lathe was not switched off since the program was last selected.
Restart
Select Prog > Restart selection
The most recently active NC program is loaded without previous
translation if:
No changes were made to the program or tool list.
The lathe was not switched off since the program was last selected.
If the “turret table” of the NC program is not the
currently valid table, there is a warning.
The name of the NC program is retained until you select
another program, even if the lathe was switched off in
the meantime.