HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 211)

HEIDENHAIN CNC PILOT 4290 211
4.1
9
T
ools, T
y
pes of Compensation
Adding tool dimensions G710
When a T command is programmed, the CNC PILOT replaces the
previous tool dimensions with new tool dimensions. When you
activate the adding function with G710 Q1, the dimensions of the new
tool are added to the dimensions of the previous tool.
Application example
For full-surface machining, the workpiece is transferred to a rotating
gripper after having been machined on the front face. The rear face is
machined by stationary tools. To do this, the dimensions of the
rotating gripper are added to the dimensions of the stationary tool.
Example of adding tool dimensions
Parameters
Q Adding tool dimensions
„ Q=0: Off
„ Q=1: On
. . .
TURRET 1
. . .
T14 ID"GRIPPER" Rotating gripper
. . .
REVOLVER 2 [TURRET] Stationary tools on tool carrier 2
T2001 ID"116-80-080.1" Roughing tool for rear-face machining
. . .
BEARBEITUNG [MACHINING]
. . .
N100 T14 Insert rotating gripper
N101 L"EXGRIGF" V1 Transfer workpiece from main spindle to rotating
gripper (expert program)
N102 G710 Q1 Adding tool dimensions
N103 T2001 Add the dimensions of rotating gripper and tool
. . .